Eagle Microsystems DCS302 - Manual (Page 10)

DRAWING KEY
ITEM DESCRIPTION P/N
1 Locknut 612541
2 Adjusting bolt, ss 400177
3 Pin, spring (split), ss, type 420 640136
4 Chain, sash, ss, 1/0 100356
5 Chain clip 400182
6 Enclosure, FG 5x5x3 630604
7 Bracket, cell, PVC-1 400244
8 Load cell, 40#, 14”, 350 ohm 500317
9 Term. block, 6 ckt, screw term. 532061
10 Lid, enclosure, FG Part of Item 6 above
11 Not used ---------
12 Screw, 10B x 5/8 Self tap, ss 611060
13 Pivot screw 400229
14 Disc 400178
15 Deck 400178
16-35 Not used ----------
36 Disc washer 400154
37 Perimeter flexure 400143
38 Perimeter clamp 400144
39 Center clamp 400145
40 Center flexure 400142
41 Short lever 400160
42 Long lever 400141
43 Screw, 6A-3/8, self tap hex 610684
44 Screw, 10-24 x 3/8 Hex head 611061
45 Screw, 10B-5/8 Self tap Phillips 611060
46 Screw, 10A-3/8 Self tap hex 611028
47 Bolt, 10-32 x 3 1/4 611013