Haltech E6GMX - Manual

E6GMX Manual
i
Warnings
1. The E6GMX ECU must only be used in the intended GM
applications with a pin-to-pin compatibility. Please contact
Haltech for an application list if required. The use of this ECU
in any other application will not be supported by Haltech in any
way and will void all warranty.
2. The E6GMX has various configurable inputs and outputs that
are predetermined by the ECU’s factory harness, such as
Thermo fan and Air conditioning control. These features can be
changed in the E6GMX at the users choice, but caution must be
taken, as the wiring of the factory harness will need to be
changed. Failure to check the wiring prior to changing an ECU
input or output may lead to damage of the ECU, harness or other
components. Damage due to incorrect wiring or software
settings will not be regarded as warranty.
3. This system is capable of controlling either “intelligent” igniters
which have in-built dwell control or “dumb” igniters which rely
on the ECU to control dwell. This allows standard igniters to be
used in many cases. Most standard igniters are dumb igniters.
However, it is very important to set the system up to match the
type of ignitor used. In the ignition set-up page the set-up should
be:
To control intelligent igniters set up as “Constant Duty”
To control dumb igniters set up as “Constant Charge”
If the wrong set-up is used the system will not function correctly
and it is possible that the igniters may burn out as a result.
Burning out of igniters due to incorrect set-up will not be
regarded as warranty.