Interlogix Simon XTi Designer Template - Manual

P/N 466-2460 • REV B • 08FEB13 1
Simon XTi Designer Template Installation Sheet
Introduction
The designer template is the adhesive-backed plastic template
that covers the front of the Simon XTi panel.
Caution: The authorized designer template and its installation
are integral parts to the reliability of the system. Replacement
of the authorized designer template should be done by the
security system installer.
Installation
Removing the designer template
1. Remove all power (both battery and AC). Use proper ESD
protection practices when replacing the designer template.
2. Remove trim ring from the panel by lifting at notch (D in
Figure 2 below).
3. Lift a corner of the template and peel back until it is
removed from the front of the panel.
Installing the designer template
Figure 1: Designer template front
422-5136-05
A
B
Figure 2: Panel cover
C
D
1. Before installing a designer template, ensure that both the
display screen and cover surface are free of any lint. Wipe
the surface down with a lint-free cloth.
2. Turn over the template to the back side (paper-backed
adhesive side).
3. Position the template so the two alignment holes (A in
Figure 1 above) are vertically located on your left side.
4. Starting at one of the left hand corners, partially peel back
the paper backing about 2 -3 inches to the right (F in
Figure 3 on page 2) exposing both of the two alignment
holes (E in Figure 3 on page 2). Crease and flatten the
partially removed paper backing against the back of the
template.