Interlogix ESL 500 Series - Manual

Installation Instructions
1. Choose a mounting location in the control panel within reach of
the leads provided. Use 50/50 water to isopropyl alcohol to
clean the mounting surface. After the surface has dried, remove
protective covering from the tape. Mount unit as shown on
control panel illustration. Route wires to the appropriate
terminals as noted below.
2. Connect 405-05 trigger wires to the fire alarm output terminals.
Observe polarity. [Gray wire to positive (+) and White wire to
negative (-)].
3. Connect 405-05 incoming power wires to the smoke detector
power source. [White-Red to (+) and White-Black to (-)].
4. Connect 405-05 outgoing power wires to the smoke detector
power in terminals. [Red to (+) and Black to (-)].
5. Connect the smoke detector initiating circuit (alarm loop) to the
alarm control.
6. Maintenance: no maintenance is required. secondary
power
Bell
Circuit
+
-
+
-
zone 01 zone 02 zone 03 zone 04 zone 06 zone 08
.
Testing: 405-05
1. Test in accordance with NFPA 72 Chapter 7 Test Methods &
Frequencies, interfacing equipment.
2. To test the 405-05 initiate an alarm with smoke or approved
test method on any detector connected to the control panel
via the 405 relay. In alarm, detectors that have responded to
smoke or test will sound in their distinct alarm patterns.
3. Reset the smoke detectors by removing power to the
detectors.
Note: For two wire smoke detectors, use the ESL 405-01 or
405-03 polarity reversal relay module.
ESL 405-05
Polarity Reversal Relay
Burglar / Fire
Alarm Control
Alarm
Output
−
+
White/Black
White/Red
White
Red
Black
ESL 400 Series Smoke
Detectors
with Sounders
End of
Line Device
ESL 204-12/24V
Power Supervision Relay
Power
Supply
Alarm
Loop
−
+
−
+
−
+
Gray
405-05
Polarity Reversal Relay Module
For use with 4-Wire Sounder Smoke Detectors and
Fire/Burglar Alarm Control Panels
Warning
This polarity reversal device may not be compatible with all
power supervision relays. When using ESL 405 Series
polarity reversal relays on four wire circuits, use the ESL
204 Series power supervision relay at the end of line. Note:
Another option is to use an ESL 449CTE (or CSTE with
Sounder) which incorporates an End-of-Line/Sensitivity
Status Relay Output.
This polarity reversal device cannot be connected to any
coded annunciator.
Typical 405-05 Mounting Locations
in the Control Panel
ESL 405-05 Polarity Reversal Relay Module
ESL 405-05 and 405-06
Relay Modules
Installation Instructions
U
L

LISTED
CSFM