Cisco 7100 Series - Manual (Page 23)

21
11 Save your settings to NVRAM by selecting option 2.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Your router is now minimally configured and ready to use. You can use the setup command if
you want to modify the parameters after the initial configuration. To perform more complex
configurations, use the configure command.
Note: If the system does not complete each of the steps in the startup procedure, proceed to
Chapter 5, “Troubleshooting the Installation,” in the Cisco 7100 Series VPN Router
Installation and Configuration Guide for troubleshooting recommendations and procedures.
For More Information
For information on additional interface configuration and specific system configurations, see
the following publications:
• Cisco 7100 Series VPN Configuration Guide that shipped with your router. This document
contains sample configurations.
• Cisco 7100 Series VPN Router Installation and Configuration Guide. This document
contains detailed information on hardware installation, software setup, and
troubleshooting guidelines.
• Modular configuration and modular command reference publications in the Cisco IOS
software configuration documentation set that corresponds to the software release installed
on your Cisco hardware.
Start the System (continued)