Campbell Hausfeld CW301300AJ EN - Manual

Pressure Switch
Assembly for Portable
Air Compressors
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
Additional Operating Instructions CW301300AJ, CW301400AJ
Description
This kit will replace pressure switch
assembly shown in Figure 1 with
pressure switch assembly shown in
Figure 2. Use this instruction guide for
assembly and operation information.
This guide is designed to supplement
the other instruction manuals included
with this unit. Carefully read all
manuals and safety information before
operating the compressor.
Components
Pressure switch - Auto/Off Switch - In
the "auto" position, the compressor
shuts off automatically when tank
pressure reaches the maximum preset
pressure. In the "off" position, the
compressor will not operate. This switch
should be in the "off" position when
connecting or disconnecting the power
cord from the electrical outlet or when
changing air tools.
Regulator - The regulator controls the
amount of air pressure released at the
hose outlet.
ASME Safety Valve - This valve
automatically releases air if the tank
pressure exceeds the preset maximum.
Removal of Existing Switch
1. Disconnect power and release all air
pressure from tank.
2. Remove existing pressure switch
cover screw(s), then remove cover.
3. Locate cut-outs on the back of
pressure switch (See Fig. 3). Insert
tip of small screwdriver into cutouts,
then push to release wires.
IN606401AV 10/04
BUILT TO LAST
O O TT UU AA
F F F F O O
4. Remove ground screw (Fig. 3).
5. Remove strain relief screw (Fig. 3).
6. Pull unloader tube off existing
pressure switch. Remove screw
holding pressure switch to pressure
switch assembly. Then remove
switch from unit.
7. Disconnect unloader tube from
check valve.
8. Remove the remainder of pressure
switch assembly by unscrewing tank
fitting.
New Switch Installation
New switch must
have same max-
imum pressure as existing switch.
Pressure rating is listed on the bottom
of assembly.
1. Screw pressure switch assembly onto
tank.
2. Replace existing unloader tube
connection at check valve with new
quick connect supplied in kit.
3. Insert new unloader tube into quick
connect fitting on check valve.
4. Insert other end of unloader tube
into unloader valve on pressure
switch. Unloader tube can be cut if
supplied length is too long.
5. Loosen pressure switch cover screw,
then remove cover.
6. Two strain relief clamps will be
provided in the kit. Determine which
strain relief clamp to use based on
the diameter of the line cord.
7. Loosely attach strain relief clamp to
pressure switch with screw provided
! CAUTION
Figure 2
OUTLET PRESSURE REGULATOR TANK PRESSURE
DRAIN
MOISTURE FROM TANK
WEEKLY TO PREVENT
TANK CORROSION AUTO OFF
Figure 1
Cutouts
Strain Relief Screw
Ground Screw
Figure 3
For parts, product & service information
visit www.chpower.com
© 2004 Campbell Hausfeld/Scott Fetzer
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
2
11
3
4
5
6
7
8
9
10
1
Notes
Notas
Additional Operating Instructions
Instructions d’Utilisation Additionnelles
Instrucciones Adicionales
CW301300AJ, CW301400AJ