Canon LV-7575 - Manual (Page 24)

24
SELECTING INPUT SOURCE
WHEN SELECTING INPUT 1 (COMPUTER INPUT TERMINALS )
Press the MENU button to display the On-Screen
Menu. Press the POINT LEFT/RIGHT buttons to move
the red frame pointer to the INPUT Menu icon.
Press the POINT UP/DOWN buttons to move the red
arrow pointer to Input 1 and then press the OK button.
A Source Select Menu appears.
1
2
Input 1
INPUT MENU
Move the pointer to a source that you want to select
and then press the OK button. 3
When your computer is connected to INPUT 1 (DIGITAL)
terminal, select RGB (PC digital).
RGB(AV HDCP)
When your computer is connected to the INPUT 1 (ANALOG)
terminal, select RGB (PC analog).
Move the pointer (red
arrow) to a source and press
the OK button.
Source Select Menu
RGB(PC digital)
RGB(Scart)
When scart video equipment is connected to the INPUT 1
(ANALOG) terminal, select RGB (Scart).
If a HDCP-compatible signal source is connected to the
INPUT 1 (DIGITAL) terminal, select RGB (AV HDCP).
RGB(PC analog)
COMPUTER INPUT
NOTE:
• INPUT SOURCE changes if the INPUT 1 button on the remote control unit is
pressed.
• HDCP (High-bandwidth Digital Content Protection) is a system for protecting digital
entertainment content which is delivered by DVI (Digital Visual Interface) from being
copied. The specification of HDCP is decided and controlled by Digital Content
Protection, LLC. Should the specification be changed, this projector may not display
the digital content protected by HDCP.
Select an INPUT source by pressing the INPUT button on
the top control or the INPUT 1, INPUT 2, or INPUT 3 buttons
on the remote control unit.
If the projector cannot reproduce proper image, select a
correct input source with the MENU OPERATION (see
below).
INPUT button
Input 1
✽Input 1 is not displayed when the Input 1 is used as
Monitor out.
NOTE:
• Input 1 terminal is switchable and can be used as Computer Input or Monitor
Output.
✽
Monitor out
If the INPUT 1 ANALOG terminal is being used as a
MONITOR OUT terminal, select Monitor out.
Input 2
Input 3
DIRECT OPERATION
MENU OPERATION
INPUT Menu icon
Move the pointer (red arrow) to Input
1 and press the OK button.