Save these instructions, Important, Pool setup (continued) – Intex 32FT X 16FT X 52IN RECTANGULAR POOL SET 2014 User Manual

Page 9: English page 9

Advertising
background image

119

PO

SAVE THESE INSTRUCTIONS

(119PO) RECTANGULAR ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/18/2013

English

Page 9

POOL SETUP (continued)

9. Position the long wall top rails so they are leaning over the

short wall top rails. Installe the corner joints

(8) at the 4

corners (see drawing 9).

IMPORTANT: The four corner joints are designed to be

moveable relative to the horizontal beams and not fixed

to the horizontal beams. This allows the pool side walls

to move inward or outward when the pool is in use.

10. Assemble the ladder. The ladder has separate assembly instructions in the ladder box.

11. Place the assembled ladder over one of the sides with one of the liner installation team members

entering the pool to smooth out all bottom liner wrinkles. While inside the pool this team member

should check the 2 drain valves (in corners) to be sure the inside drain plug is inserted into the valve.

This team member should push each inside corner in an outward direction.

12. Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain

cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check

to see whether the water is level.

IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting

up the pool on unleveled ground will cause the pool to tilt resulting in the sidewall material to

bulge. If the pool is not completely level, you must drain the pool, level the area and re-fill the

pool.

Smooth out the remaining wrinkles (from inside pool) by pushing out where the pool floor and pool

sides meet. Or (from outside pool) reach under the side of the pool, grasp the pool floor and pull it out.

If the ground cloth is causing the wrinkles, have 2 people pull from either side to remove all wrinkles.

13. Fill the pool with water up to just below the sleeve line.

(see drawing 10).

NOTE: The pool side walls and frame structure will lean

inward after having been filled with water to the

recommended level. Do not be concerned by the inward

leaning of the side walls, this is to accommodate the water

movement and pressure when the pool is in use.

14. Posting aquatic safety signs

Select a highly visible area near the pool to post the Danger

No Diving or Jumping sign included later in this manual.

9

8

IMPORTANT

Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that

include, at a minimum, the important safety rules and general aquatic safety information in

this manual. Review these rules on a regular basis and with all users of the pool, including

guests.

WATER LEVEL

10

Advertising