Intex CL1110 2014 User Manual

Save these instructions, Warning, Intex

Advertising
background image

169

PO

(169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25” 07/10/2013

SAVE THESE INSTRUCTIONS

Page 1

(169PO) MULTIFUNCTION LED LIGHT ENGLISH 4.875” X 7.25” 07/10/2013

SAVE THESE INSTRUCTIONS

Page 2

169

PO

READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT

INTEX

®

OWNER'S MANUAL

MULTIFUNCTION LED LIGHT 3 AAA Cell Size Batteries Model CL1110

General Information

• This product operates on three (3) AAA size batteries (not included). LED light wattage: 1 W.

• For maximum power use alkaline batteries. Remove batteries from equipment which is not to be used for an extended

period of time.

• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium)

batteries.

• Remove used batteries promptly.

• Always purchase the correct size and grade of battery most suitable for the intended use.

• Replace all batteries of a set at the same time.

• Clean the battery contacts and also those of the device prior to battery installation.

• Ensure batteries are installed correctly with regard to polarity (+ and -).

• The LED is a lifetime light source. It will never need to be replaced.

• The operating time for this product depends on whether it is run continuously or intermittently. Intermittent use extends the

operating time of a set of batteries.

• Two additional battery holders are provided to hold two sets of three (3) AAA size batteries.

• To clean the product, use only a damp cloth. Avoid strong cleaner, excessive water and abrasive brush.

Due to a policy of continuous product improvement, Intex reserves the right to change specifications and appearance, which

may result in updates to the instruction manual, without notice.

Adult use only. This product is not a toy, keep away from children.

• Do not stare directly at the light emitted by this product.

• This product is resistant to rain and splashing water, but it is not submersible. Do not drop into or

immerse in water.

WARNING

Functions and Operation

• ON/OFF push button: Sets light brightness in lantern and flashlight mode (see Fig 1 A):

* Based on 3 AAA fresh alkaline batteries.

• Function-switch: Selects operating mode via 3-way switch (see Fig. 2B):

Note: The 3-way switch functions take priority over the

ON/OFF push button functions. The brightness of the

flashing hazard light and emergency beacon light are

defaulted to full power (100%) and cannot be adjusted.

169-*PO-R0-1407

Press Button

Brightness

Percent

Battery Life

Once

Low

8%

* 28 hours

Twice

Medium

50%

* 3 hours

Three times

High

100%

* 1 hour

Four times

Off

Fig 1 A

Fig 2 B

Switch

Position

Function/Operating Mode

SOS

Emergency beacon – international SOS signal light

o

Lantern/Flashlight mode/OFF

HAZARD

Flashing hazard light

Advertising