Jaypro Sports FPS-30P - Manual

DATE: DRAWN BY:
10/17/2013
MODEL NUMBER: CHECKED BY:
PRODUCT NAME:
Moune T.
FPS-30P
FOUL POLE GROUND SLEEVE FOR
MODEL BBFP-30 FOUL POLE
WVB
REV:
-
SHEET:
1 OF 1
3" BELOW GROUND LEVEL
CONCRETE
6X 3/4" x 48" REBAR
(NOT INCLUDED TO BE PROVIDED BY INSTALLER)
FPS-30P
FOR SEMI-PERMANENT INSTALLATION OF FOUL POLE BBFP-30
36"
66"
6" CRUSH STONE OR BLOCK
HOLE IN BASE PIPE NEEDS TO BE DRILLED
TO ALLOW 1/2" HARDWARE TO
PREVENT FOUL POLE FROM ROTATING
GROUND SLEEVE: INSTALLATION INSTRUCTIONS
1) DIG FOOTING AT PROPER LOCATION 36" x 66" DEEP.
2) POUR A 6" FOOTING PAD AND ALLOW TO FULLY CURE OR PLACE SLEEVE ON TWO 6"
CONCRETE BLOCKS, SEE STEP 3 FOR HEIGHT OF SLEEVE BEFORE POURING FOOTING.
3) SET SLEEVE APPROXIMATELY 1" ABOVE GROUND LEVEL SO 1/2" HARDWARE IS NOT EXPOSED,
PLUMB SLEEVE BEFORE POURING CONCRETE AND ALLOW THE CONCRETE TO FULLY CURE FOR
48 HOURS.
4) CAREFULLY SLIDE FOUL POLE SECTION INTO SLEEVE. ORIENT FOUL POLE PROPERLY AND
LOCK INTO POSITION USING 1/2" HARDWARE. (PROVIDED WITH JAYPRO FOUL POLE: BBFP-30)
SLEEVE TO EXTEND 1" ABOVE GROUND LEVEL
IMPORTANT NOTE:
1) CHECK LOCAL BUILDING CODES BEFORE STARTING THE FOOTING, AS BUILDING CODES MAY VARY. LOCAL
BUILDING CODES SHOULD BE ADHERED TO IF REQUIREMENTS ARE GREATER THAN THOSE OUTLINED HERE.
2) THESE ARE SUGGESTED DIMENSIONS FOR AVERAGE SOIL CONDITIONS, CONSULT LOCAL BUILDING CODES.
OUTFIELD FENCE
FOUL POLE PANEL IS
ALIGNED WITH OUTFIELD FENCE
OUTSIDE OF FOUL POLE FLUSH
WITH OUTSIDE OF FOUL LINE
FOUL LINE