Juniper Systems Allegro Top Mounting Bracket - Manual

Installing the Top Mount Bracket on the Allegro
The top mount bracket for the Juniper Systems Allegro can be used
in a variety of mounting applications. Originally designed for a GPS
antenna mated with a separate GPS receiver system, it can also be
used with Bluetooth devices like barcode scanners, RFID readers, and
standalone GPS devices.
Installing the top mount bracket on the Allegro is a simple seven-step
process. To complete this, you will need a thin, narrow, metal object.
Caution: Do not use a sharp knife as this could damage the case.
1. Remove the existing on-board stylus from the top of the Allegro.
Figure 1: Remove stylus from Allegro
2. Loosen the thumbscrews on the bracket until the nuts reach the
top of the threads. It is not necessary to remove the nuts.
Figure 2: Loosen thumbscrews.
3. Place the mount in position at the top of the Allegro with the
flat face of the mount close to the same plane as the Allegro’s
display. See Figure 3.