Chamberlain LSIA - Manual (Page 2)

2
Assemble Intercom
Step 1
Step 2
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Programming Intercom
Adhere rubber pads to bottom.
Repeat Steps 1 and 2 for any additional intercoms.
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put the second
intercom into Learn Mode (refer to the following
table).
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put any networked
intercom into Learn Mode (refer to table below).
Press and release the Talk button to verify network is
complete.
INTERCOM LEARN MODE
Press the Learn
button until a
beep is heard.
Press and hold
both buttons for
5 seconds.
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form a
separate network and the memory will need to be
cleared.
OR
INTERCOM LEARN MODE
Press the Learn
button until a
beep is heard.
Press and hold
both buttons for
5 seconds.
OR OR