Chatsworth Products RIM-600 User Manual
Chatsworth Products Hardware
Advertising
Remote Infrastructure Management
(RIM-600)
User Manual
Version 1.04
800-834-4969
www.chatsworth.com
©2006 Chatsworth Products, Inc. All rights reserved. CPI and MegaFrame are
registered trademarks and TeraFrame is a trademark of Chatsworth Products, Inc.
All other trademarks belong to their respective companies. MKT-60020-328-GT 1/06
Advertising
Table of contents
Document Outline
- Cover
- Safety, Introduction, Warranty
- Table of Contents
- Chapter 1:Installation
- Introduction
- About This Manual
- HOST INSTALLATION and CONFIGURATION
- Physical Description
- Installation
- Operating Environment
- Network Configuration
- Battery Maintenance
- RIM-600 Host Specifications
- Operating Specifications
- Communications Specifications
- Environmental Monitoring
- NODE INSTALLATION & CONFIGURATION
- Physical Description
- Installation
- Operating Environment
- Network Configuration
- Node Specifications
- Operating Specifications
- Communications Specifications
- Environmental Monitoring
- Chapter 2: RIM-600 Software
- Introduction
- RIM-600 Quick Start Guide
- Install Units and Configure Network Settings
- Install Software and Log In to Host
- Default Username and Password
- Configure the Unit Properties for the Host and Node(s)
- Configure Input Templates
- Connect Environmental Sensors to Host and Node(s)
- Configure User Profiles and Contacts
- Configure IP Alarms
- Record and Assign Voice Messages
- Software Installation and Hardware Requirements
- Hardware and Software Requirements
- Software Installation
- Configuring Hosts and Nodes
- Setting Up An Enterprise
- Setting the Unit Properties for the RIM-600 Host
- Changing Host Network Settings using ConsoleView
- Setting the Unit Properties for the Node
- Changing Node Network Settings
- Configuring Environmental Inputs
- Alarm Response via the PowerGate, PowerGate2, or Camera
- High Sound Alarms
- Realtime Strip Chart
- Environmental Input Alarm Logic
- Trouble Alarms
- Removing/Changing a Sensor
- Configuring IP Alarms
- IP Alarm Setup
- Alarm Logic
- Input/Alarm Classes
- Configuring User Profiles and Contacts
- Configuring User Profiles
- Adding a Profile
- Contacts
- Alarm Delivery Options
- Saving and Loading Programming
- Reconnecting
- Recording and Uploading Voice Messages
- Holiday Setup
- Alarm Message Pop-Ups
- E-Mail Setup and Two-Way E-Mail Commands
- Configuring a Video Camera
- Web Page
- Graphs
- History
- Datalog History
- Updating Firmware