Cisco OL-21851-01 - Manual

C H A P T E R
5-1
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
5
Configuring and Managing the Cisco Unified IP
Phone
Revised: March 4, 2013, OL-21851-01
Note This chapter does not apply to systems that use a Touch 12 device for call control or that use software
release 6.0.0 or later. Midlets are only used for systems that use a Cisco Unified IP Phone for call control.
Contents
This chapter describes how to configure and manage the Cisco Unified IP Phone and the Enhanced
Phone User Interface that uses Java
MIDlets on the Cisco Unified IP phone.
This chapter contains the following information:
• Important Notes, page 5-1
• Configuring the Cisco Unified IP Phone, page 5-2
• Creating MIDlets IP Phone Service in Unified CM, page 5-19
• Configuring MIDlets, page 5-18
• MIDlets Troubleshooting Tips, page 5-21
• Assigning a Directory Number for the Shared-Line Cisco Unified IP Phone, page 5-22
• Verifying and Troubleshooting IP Phone Configuration, page 5-24
Important Notes
See the following advisories and important notes that may affect system behavior:
• MIDlets Software Releases, page 5-1
• Adding a New Phone with MIDlets Capability, page 5-2
MIDlets Software Releases
The supported MIDlets version is embedded in the software files that are available on the Cisco Unified
Communications Manager Support page at the following URL:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/tsd_products_support_series_home.html