Cisco 7301 - Manual (Page 4)

4
Prepare for Workbench or Tabletop Installation
For a workbench or tabletop installation, verify the following before installing the router:
• The router is off the floor and has adequate ventilation.
• An adequate chassis ground (earth) connection exists for the router.
• The router has at last 3 inches (7.62 cm) of clearance at the inlet and exhaust vents (sides of router).
• The router has 19 inches (48.3 cm) clearance at the front and rear to allow for CompactFlash Disk, SFP Gigabit Interface
Converter (GBIC) module, and port adapter replacement or installation, or to access cables or equipment.
• The port adapter filler panel is installed if a port adapter is not installed. The slot must not be empty.
For cable-management bracket installation instructions, see page 9.
Prepare for Rack-Mount Installation
Before you begin the rack-mounting tasks, decide whether or not you want to front- or rear-mount the chassis, decide whether
or not you want to attach the cable-management bracket, and determine the type of rack—four-post or two-post—that you will
be using.
3
Install External Options
This section provides installation instructions for the Gigabit Ethernet SFP Gigabit Interface Converter (GBIC) module. It does
not ship installed.
Figure 1 Cisco 7301 Front Panel
1 Port adapter 9 Auxiliary port
2 Port adapter latch 10 Console port
3 RJ-45 port GE 0/0 11 CompactFlash Disk ejector button
4 Gigabit Ethernet SFP GBIC port 0/0 12 Ground for ESD wrist strap with banana jack
5 RJ-45 port GE 0/1 13 Alarm port
6 Gigabit Ethernet SFP GBIC port 0/1 14 Power switch
7 RJ-45 port GE 0/2 15 CompactFlash Disk slot
8 Gigabit Ethernet SFP GBIC port 0/2 16 Power connector
ALARM
RJ45 EN
LINK
TX RX GBIC
GIGABIT ETHERN
ET 0/2
RJ45 EN
LINK
TX RX GBIC
GIGABIT ETHERN
ET 0/0
RJ45 EN
LINK
TX RX GBIC
GIGABIT ETHERN
ET 0/1
CISCO 7301
SLOT 1
CONSOLE
AUX
COMPACT
FLASH STATUS
100-240V , 2A, 50/60 H z 24V=9A, 48 - 60V
=5A
ENABLEDRX CELLSRX CARRIER
RX ALARM
ATM
80265
12
1
3
5
7
14
2
4
6
8
15
11 13
9 10
B
A
16