Kannad Marine DW-LJH5D/A1 - Manual

Kannad Marine R10 SRS
Instructions for fitting to the Spinlock Deckvest
This document relates to fitting the Kannad Marine R10 SRS to the following models of Deckvest:
DW-LJH5D/A1 DW-LJH5D/H1 DW-LJH5D/C2
DW-LJH5D/A2 DW-LJH5D/H2 DW-LJH5D/C3
DW-LJH5D/A3 DW-LJH5D/H3
If you are unsure on fitting the Kannad Marine R10 SRS in your Deckvest Lifejacket then it should be fitted by
qualified lifejacket personnel working in Service Centres authorised by Spinlock.
Overview: The Kannad R10 is attached to lifejacket using the oral inflation tube. It is designed to be activated
by the force created by the inflation of the lifejacket pulling off the red cap, which releases the antenna and
turns the unit ON. The method of attachment has been devised to hold the Kannad R10 firmly in place while
the red cap is pulled away by the inflating bladder.
PREPARING THE R10 YELLOW LINE
Undo the orange tab so it hangs down.
The R10 is normally supplied with the yellow line
knotted onto the white section of the R10 (ready for
manual activation only). Undo this knot, so there is a
short line to the orange tab and a long loose line.
PREPARING THE ORAL TUBE CLIP
Assemble the Oral Tube Clip (supplied loose)
as shown and slide onto R10
Back of R10