Keri Systems EntraGuard Titanium Installation Guide - Manual

EntraGuard
®
Titanium Telephone Entry Controller
Installation Guide
Page 1 of 6 P/N: 01551-001 Rev. B
This installation guide provides basic installation information, drawings, and controller setup instructions to use when
installing the EntraGuard Titanium Telephone Entry controller. The EntraGuard Titanium controller may be used alone or
may be connected to an access control network using PXL-500 or PXL-250 family controllers. For instructions on how to
install a postal lock, see the EntraGuard Titanium Postal Lock Installation Application Note (P/N 01964-001).
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the
installation.
Section 1 - Drawings
Section 2 - RS-232 Serial Port
Section 3 - Setup Controller
Section 4 - Contact Keri Systems
1.0 Drawings
Figure 1: The EntraGuard Titanium Telephone Entry Enclosure