KERO PakCanoe Spray Cover - Manual

1Installation Instructions for
PakCanoe Spray Cover
The following items are needed to install the Spray Cover:
1. The Spray Cover itself is in two parts. The longest part (about 2/3 the length of the
boat is the bow section).
2. 100 ft (30 m) of sturdy nylon or polyester cord.
3. PVC adhesive (glue).
4. Black PVC patches (supplied with the cover).
Installation procedure :
1. A cord needs to be installed along each side of
the canoe all the way around the hull (see
illustration). You need to glue on the black
patches, and we recommend that you start at the
center on each side of the canoe. The easiest way
to find the center is to locate the center of the
logo. It is easiest to install the patches before you assemble the canoe.
2. The easiest way to place the patches correctly is to
use a template (see illustration on the right). One can
easily be made from a piece of cardboard. Line up the
top edge of the template along the seam that closes
the gunwale channel of the canoe skin. For the first
patch, place the template so that the hole is directly
below the center of the Pakboats logo. Follow
instructions in point 3 and 4.
3. Brush a thin layer of glue onto the fabric exposed by the
hole and onto the part of one black patch that will be glued
to the canoe side (See illustration on right).