Kuzma Stabi XL 2000 - Manual (Page 5)

5
Basic Setup:
Note: Some parts are very heavy, so be careful when handling!
Note: Choose a suitable supporting table which can hold over 80 kg without warping.
Note: While the parts are packed in plastic bags for protection, these are not intended to be
strong enough to lift or carry the contents.
Open all three boxes and remove top covers.
Base:
Locate the main brass base with the shaft. This is very heavy. Lift, being careful not to
scratch against metal parts of clothing, and position in the middle of the supporting board.
The Kuzma logo should face forward. Use a ruler to position the centre of the base.
Motor towers:
Remove the two brass motor towers with black pulleys being careful not to touch the pulleys
with any force. Position each motor separately in the rounded cutout on each side of the
main base, so that the connectors are at the rear side. The gap between the base and the motor
towers should be 2 mm and both perimeters should appear parallel. See Fig 1.
Distance of motors. Fig. 1.
Subplatter:
Remove the protection cover from the shaft and see if there are any dirt particles in the area
of shaft and ruby ball. Remove these using a soft cloth and further clean the area if
necessary with a cloth soaked in alcohol.
Oil should be poured into the reservoir on top of the shaft (where the ruby ball is located )
until it is full and oil starts to run into the lower reservoir. Then empty the rest of oil into
this lower reservoir. The level of oil is not critical due to the construction of the bearings.
Note: there is a spare bottle of oil!
Carefully put the aluminium subplatter over the shaft as vertically as possible and gently
lower by rotating it back and forth. When lowered, ensure that rotation of the subplatter feels
free and firm. If your hands are sweaty or sticky from the oil, clean the outer surfaces of the
subplatter with a cloth soaked in alcohol.