Leslie Controls AEROFLOW SUPPLEMENT Special Mini-P Design - Manual

12501 Telecom Drive, Tampa Florida 33637
Installation, Operating and
Maintenance Instructions
Supplement
10/2.5.1.H
Rev. 0
AEROFLOW SUPPLEMENT
Special Mini-P Design
TABLE OF CONTENTS
INSTALLATION ......................................................................................................................................... 1
MAINTENANCE ......................................................................................................................................... 1
TABLE OF FIGURES
F
IGURE 1 – 3” A EROFLOW WITH SPECIAL M INI -P T RIM SET ............................................................................ 2
INSTALLATION
NOTE: Refer to Fig. 1 for installation.
1.
Install seat gasket (1) into valve body.
2.
Install cage/liner (2), gasket (3), and seat (4)
into valve body.
3.
Install body/bonnet gasket (5).
4.
The bonnet will need to have a relief
machined into it per Leslie dwg 38214C,
included with the change out kit to
accommodate this trim design.
5.
Install the pison ring (6) onto the valve main
plug (7).
6.
Install the pilot plug assembly (8) into the
main plug (7).
7. Install the capscrews (9) and torque to 6 ft-
lbs. Tie wire cap screws together.
8.
Complete the bonnet installation as stated in
the valve IOM.
MAINTENANCE
1. During routine maintenance the trim should
be carefully inspected for wear and replaced
as needed.
2.
The valve IOM should be followed for all
operating and maintenance procedures.
CAUTION!
All warnings/notes from valve IOM 10/2.5.1 must be
followed.