Milwaukee Tool 6740-20 Wiring 2003 - Manual

DOUBLE REDUCTION PISTOL GRIP TOOLS
58-01-1805
DATE
Jan. 2003
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS.
BULLETIN
WIRING INSTRUCTIONS
TITLE
Drwg. 3
Terminals, Connectors and 1 or 2 End Wire Preparation
Wire
Color
Origin or
Gauge
Wire
No. Length
WIRING SPECIFICATIONS
BULK LEAD WIRE - BULLETIN NO. 58-01-0003
Grounding terminal
Green ground wire #3 connects
to male tab of grounding terminal.
Position terminal as shown.
(Grounded models only).
Route blue brush wire #5 and
white brush wire #6 through
wire traps over rear bearing
bore as shown.
FOR DOUBLE INSULATED TOOLS
DISREGARD GREEN GROUND WIRE #3
AND THE GROUNDING TERMINAL
Insert black wire #1
in the hole marked
2
↓ on the bottom
of the switch
Heat
Sink
For grounded tools with
3-wire quik-lok cords,
orientate the pin housing
assembly as shown and place
white wire #2 first into the
bottom of the handle portion of
the motor housing. For double insulated tools
with 2-wire quik-lok cords,
orientate the blade housing
assembly as shown and place
white wire #2 first into the bottom
of the handle portion of the motor
housing.
In the main trap, route green ground wire #3
in the bottom followed by the white wire #2
and black wire #4 on the top.
Route black lead #4 through any of the three
traps on the tab of the motor housing and
insert into hole 2 on bottom of switch (Hole is
marked with a 2 on side of switch).
Route green ground wire #3 and
white wire #2 around the post in
the motor housing. Wires cannot
touch the heat sink of the switch.
Post
Rear bearing bore
Fixed cord
shown
Black wire #1 Black wire #4
If screw is
present
seat
screw
fully.
Bottom
view of
switch
1 Black * ----- *Component of cord set, pin hsg. assy. or blade hsg. assy.
2 White * ----- *Component of cord set, pin hsg. assy. or blade hsg. assy.
3 Green * ----- *Component of cord set, pin hsg. assy. or blade hsg. assy.
4 Black ** ----- **Component of the brush card assembly.
5 Blue ** ----- **Component of the brush card assembly.
6 White ** ----- **Component of the brush card assembly.
7 Brown ** ----- **Component of the brush card assembly.
Route green ground wire #3 and jumper wire (white)
in recessed area of brush card as shown.
.25 min.
SCHEMATIC
T2
T2
(T1)
TERMINAL DESCRIPTION
Part No. Code Qnty.
T1 23-74-0605 1
T2 23-74-1060 4
Jumper
Wire