Motion Pro 08-0544 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
STEERING STEM BEARING TOOL P/N 08-0544
I08-0544 5/2014
Here’s what you’ll need to complete the removal
and installation of your steering stem bearing.
A. Soft mallet/hammer
B. 3 mm Allen wrench
C. 19 mm wrench
D. Cutter pliers or screwdriver
E. New steering stem bearing
F. Waterproof grease (not shown)
1. Remove outer cage of the old bearing using cutters as shown in the photo. A screwdriver can also be used to remove
the old bearing.
2. Slide bearing puller adapter over steering stem to base of steering stem. Tighten setscrews evenly and lightly under
top lip of bearing race. Do not tighten setscrews more than finger tight or race will bind against stem.
3. Place protector cup on top of the steering stem to protect the threads from damage.
4. Slide the Steering Stem Bearing Tool body over steering stem and screw all the way into bearing puller adapter.
5. Using a 19 mm wrench tighten the puller bolt to remove the old bearing.
6. Clean the base and steering stem making sure it is clear of any dirt, grime or debris.
7. Install new bearing onto the stem.
8. Select the correct size driver for your application and install it onto the end of the Steering Stem Bearing Tool. Remove
the drive bolt and use a soft mallet to drive the new bearing into place. It’s not a bad idea to use a block of wood under
the triple clamp to support the bottom and protect it from damage. Make sure that the bearing is fully seated onto the
stem and grease the bearing with high quality waterproof grease.
A
B
C
D
E
1
5
2
6
3
7
4
8