Motion Pro 11-0062 - Manual

ARMOR RIM STRIP TAPE P/N 11-0061 & 11-0062
Step 1
CLEAN YOUR RIM (do not use WD-40
or other like products that leave an oily
residue as this will prevent the tape
from sticking correctly)
Step 2
Peel paper backing off the tape just past
the hole on the short end.
Step 3
Align the hole in the tape with the
Schrader valve hole on the rim, and
press down the exposed adhesive
section of the tape.
Step 4
Continue by simultaneously
pulling off the paper backing
and firmly seating the rim
tape over the spoke nipples
in the center of the rim until
the two ends overlap.
Step 5
Cut the hole for the rim lock with a
hobby knife once the tape has been
fully installed.
USE CAUTION WITH THE HOBBY KNIFE TO
AVOID INJURING YOURSELF.
ARMOR RIM STRIP TAPE P/N 11-0061 & 11-0062
Step 1
CLEAN YOUR RIM (do not use WD-40
or other like products that leave an oily
residue as this will prevent the tape
from sticking correctly)
Step 2
Peel paper backing off the tape just past
the hole on the short end.
Step 3
Align the hole in the tape with the
Schrader valve hole on the rim, and
press down the exposed adhesive
section of the tape.
Step 4
Continue by simultaneously
pulling off the paper backing
and firmly seating the rim
tape over the spoke nipples
in the center of the rim until
the two ends overlap.
I11-0061
9/2009
Step 5
Cut the hole for the rim lock with a
hobby knife once the tape has been
fully installed.
USE CAUTION WITH THE HOBBY KNIFE TO
AVOID INJURING YOURSELF.
I11-0061
9/2009