Cisco Cisco Unified Wireless IP Phone 7925G - Manual (Page 75)

Using a Handset, Headset, and Speakerphone
Cisco Unified Wireless IP Phone 7925G for Cisco Unified Communications Manager 7.0 67
If you want to... Then...
Enable/disable Bluetooth
on your phone 1. Choose > Phone Settings > Bluetooth.
2. Highlight Bluetooth and press Select.
3. Select Enable or Disable, then press Save.
If enabled, the Bluetooth enabled icon appears. If disabled, the
icon disappears.
Note Bluetooth must be enabled on the phone before you can perform
tasks such as scanning, pairing, and unpairing.
Scan for Bluetooth devices 1. Choose > Phone Settings > Bluetooth > Device List.
2. Press Scan. A list of devices appears.
Note It may take a few seconds for the scan to complete. You might need
to rescan for a device. To rescan, press Rescan from Scan Results.
Pair a Bluetooth headset
with the phone 1. From the Scan Results list, select a Bluetooth headset and press
Pair.
2. When prompted, enter the Bluetooth Passkey, then press
(Select) or Options > OK.
Note Obtain the Bluetooth Passkey from your Bluetooth device
documentation. Pairing must be completed within one minute or it
will fail.
3. If the pairing succeeds, the newly paired headset is added to the
Device List and becomes connected to the phone (if no prior
Bluetooth connection exists between another device and the
phone.) If a prior connection exists, first unpair or disconnect the
other device from the phone.
The Bluetooth device connected icon is displayed, and a
checkmark appears next to the device name.
4. If the pairing fails, press Back to retry.
Connect a Bluetooth
headset already paired (but
not connected) with the
phone Do one of the following:
• Tap on the headset to send a connection request to the phone.
• Choose > Phone Settings > Bluetooth > Device List,
highlight the headset, and press Options > Connect.