Mutable Instruments Ripples - Manual

Ripples
Liquid filter
Installation
Ripples requires a -12V /
+12V power supply (2x5 pin
connector). The ribbon cable
connector must be aligned
so that the red stripe of the
ribbon cable (-12V) is on the
same side of the module’s
power header as the “Red
stripe” marking on the
board.
The power consumption is:
+12V: 35 mA; -12V: 35 mA
Calibration
Adjust the trimmer on the
back of the module so that
the tone emitted by the filter
(when it self-oscillates)
tracks a 1V/oct CV sent to
the FREQ input.
Online manual
and help
The full manual can be
found online at
mutable-instruments.net/
modules/ripples/manual
For help and discussions,
head to
mutable-instruments.net/
forum/