Neu-F NF.200 - Manual

Gauze-Type Air Filter Cleaning Instructions
Interval cleaning recommendations: Normally 10-12K miles or sooner for dirty and dusty
environments.
1. Remove filter. Lightly tap filter on surface to remove large debris.
2. Apply cleaner. FOLLOW ALL SAFETY INSTRUCTIONS ON THE AIR FILTER
CLEANER BOTTLE. Spray Air Filter Cleaner onto both sides of the air filter until it
completely saturates the pleated material. Allow cleaner to soak into air filter for 10
minutes to loosen the dirt. Do not let cleaner dry on air filter.
3. Rinse off air filter with cool low-pressure water. Allow gravity to flush dirt out of air filter
by applying water to the inside of the filter; up and down the length of the pleats.
Continue to rinse the filter until all traces of cleaner are gone. If the filter is extremely
dirty it may be necessary to repeat steps 2 and 3.
4. After rinsing, gently shake off excess water and allow filter to dry naturally. Do not oil
until the filter is completely dry. NOTE: DO NOT USE COMPRESSED AIR, DRYER
HEATERS OR HEAT GUNS TO SPEED UP THE DRYING PROCESS.
5. Apply air filter oil to the outside of the filter only. Using the aerosol spray can, spray an
even amount of oil along the crown of each pleat. Wait 20 minutes for the oil to be
absorbed into the filter media. Touch-up any area with oil until there is an even red
color over the entire surface of the clean filter.
6. Reinstall filter.