NM Engineering 658857 User Manual

NM Engineering For the car

Advertising
background image

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX

[email protected] ∞ www.nm-eng.com

 
 
 

 






PARTS INCLUDED:

[1] Stainless steel intake pipe bracket [1] Stainless steel fresh air hose bracket [1] 90° Silicone hose [2] M8 Washers
[1] Aluminum intake pipe connector

[1] Air filter

[2] #44 Hose clamps [2] M8 Lock nuts

[2] SS Button head bolts M6 x 16mm [1] SS Button head bolt M6 x 10mm

[2] M6 Lock nuts

TOOLS & SUPPLIES REQUIRED:
[1] T25 TORX Driver

[1] T30 TORX Driver

[1] 7mm Nut Driver

[1] Screwdriver

[1] 10mm Socket or Wrench

[1] 13mm Socket or Wrench [1] 4mm Hex key wrench [1] Needle nose pliers

[1] Degreaser or contact cleaner [1] Clean shop rag

[1] 8mm Nut Driver



1.

Loosen hose clamp at Mass Air Flow sensor (MAF) to turbo
intake tube using 7mm nut driver or screwdriver.

2.

Squeeze tab on electrical connector to disconnect from MAF.

3.

Separate brake booster line holder from fresh air intake hose.
Use needle nose pliers to squeeze tabs and then push out
holder.

4.

Remove T25 TORX screw located on passenger side of air
filter box and lift off. NOTE: There are [3] pin mounts that are
pushed into rubber grommet mounts on intake manifold, so
effort may be required to lift air filter box off of mounts.

5.

Locate fresh air pipe that is attached to air filter box.
Disconnect fresh air pipe by rotating the 90° connection
counter clockwise and pulling pipe away from air filter box.
Remove air filter box from vehicle.


6.

Remove MAF sensor from air filter box by removing [2] T30
TORX screws.

























7.

Install MAF sensor to NM stainless steel intake pipe bracket
using supplied M6 x 16mm button head bolts and M6 nuts.
[4mm hex key wrench / 10mm socket or wrench]


8.

Install NM SS bracket onto factory air filter box mounts.
NOTE: Make sure rubber grommets are still in place and not
attached to bottom of the OE air filter box. From bottom side
of mounts, install and tighten using supplied M8 washers and
M8 lock nuts. [13mm wrench]

HI-FLOW INDUCTIONS KIT* – NM.658857

[R55] MINI Cooper S & JCW Clubman 2011-up
[R56] MINI Cooper S & JCW Hardtop 2011-up
[R57] MINI Cooper S & JCW Convertible 2011-up
[R60] MINI Countryman 2011-up

Advertising