Char-Broil TRU 11101625-A1 User Manual
Page 6
A
B
C
G
E
D
H
A)
Power Button
B)
Temperature Control Buttons
C)
Temperature Display
D)
Temperature Display Indicator
E)
Temperature Mode Button
F)
Power Level Buttons
G)
Power Level Display
H)
Digital Food Thermometer Jack
To Turn On:
•
Plug power supply cord into a properly grounded, GFI protected outlet. If extension cord must be used refer to Extension
Cord Use and Safety” on page 3.
•
Press Power Button to turn on display.
•
The Current temperature of the Digital Food Thermometer is displayed in the Temperature Display in °F.
•
If “--- “ is displayed, check to make sure the Digital Food Thermometer is fully plugged into the Digital Food Thermometer
Jack.
Note: Each time a button is pressed, an indicator beep sounds. To disable beep, press and hold the Temperature Mode Button for
two seconds. Repeat to turn on.
Note: Roaster will automatically shut off 12 hours after pressing the Power Button.
To Set Target Food Temperature:
•
Press the “+”or “-“ Temperature Control Button until the desired Target Food Temperature is reached.
o
See USDA Guidelines for cooking meat on page 5.
•
Unit will continue on heat cycle until Target Food Temperature is reached.
•
Food Temperature Display will alternate between the Current temperature of the food and the Target temperature.
•
Once Target Food Temperature is reached, an alarm sounds and the heat cycle is turned off. The controller will beep once
every 30 seconds until the Power Button is pressed.
Note: Press and hold the “+”or “-“ Temperature Control Button for 2 seconds to scroll rapidly through the temperatures
Press Temperature Mode Button to alternate between °F and °C.
To Roast:
•
Press the “+” Power Level Button to set the Power Level at 15. Allow unit fifteen minutes to preheat prior to adding food.
•
Adjust Power Level as desired.
To Smoke:
•
Fill smoke box with wood chips or pellets. For best results, do not fill above the top of the smoke box.
•
Press the “+” Power Level Button to set the Power Level at 15. Allow fifteen to twenty minutes for smoke to begin.
•
Adjust Power Level as desired.
•
Refill smoke box as needed during cook cycle.
To Clean:
•
Press “+” Power Level Button until “C” is displayed on the Power Level Display.
Note: The clean cycle lasts 30 minutes, after which the unit will turn off.
CONTROLLER OPERATION
Page 6
F