Oakworks Paper Roll Holder - Manual

Snap buttons on insertion
rods secure the unit
to the table.
Independent snap button adjustments on
the paper roll arm accommodate paper sizes
from 18” to 32” in width.
The Professional’s Choice
Fig. 1
Fig. 2
Fig. 4
Instructions for Installation:
OAKWORKS
®
Paper Roll Holder
Toll Free Phone: 800-558-8850 Phone: 717-235-6807
Toll Free FAX: 877-562-4787 FAX: 717-235-6798
www.oakworks.com
OAKWORKS ® , Inc.
923 East Wellspring Rd., New Freedom, PA 17349
Fig. 3 Elastic strap holds the paper down
Elastic strap
Part no. 6487 Rev. 8.2.13
1. Hold the snap buttons in (Fig 1) and insert the rods into the
outlets at either end of the table. (Fig .2)
2. Use the smaller snap buttons on the paper roll arm to adjust it
for the accomodation of paper rolls from 18” to 32” in width.
(Fig.1)
3. To remove the unit from the table, push in on the snap
buttons from underneath the table and pull the insertion
rods out.
4. The tough powder coated finish makes cleaning easy: just wipe
with a soft cloth or sponge and mild soapy water.
Instructions for Attaching & Using the Elastic Strap
This Elastic Strap holds your paper down close to the table at the
opposite end from the Paper Roll Holder.
5. The length of elastic included with your Paper Roll Holder is
stitched in a continuous loop, like a giant rubber band. Simply
slide this elastic band over the end of the table opposite to the
end on which you installed the Paper Roll Holder.
6. Pull a length of paper from the Paper Roll Holder, across the
top of the table and tuck the paper underneath the elastic.
(Fig.3).
7. Your table is now protected and ready for your client. (Fig. 4)