Crestron electronic Adagio AAE - Manual (Page 9)

Crestron Adagio™ AAE Audio Expander
Connectors, Controls and Indicators (continued)
# CONNECTORS,
CONTROLS, &
INDICATORS
DESCRIPTION
8 SETUP (LED and
button)
Used to setup unit’s Net ID in conjunction
with Crestron Toolbox.
9 LOOP THRU 2 un-powered Cresnet ports paralleled with
NET ports 1-6 (supplied). For connection to
Adagio control unit or 2-Series control
system and additional AAE units.
Pin 1 No Connection
Pin 2 (Y) Data
Pin 3 (Z) Data
Pin 4 (G) Ground
1. Refer to “Fuse Replacement” on page 8 for additional details.
2. Refer to “Hardware Hookup”, which begins on page 6 for additional cord details.
Industry Compliance
This product is Listed to applicable UL Standards and requirements by Underwriters
Laboratories Inc.
(E302724)
As of the date of manufacture, the Adagio AAE Audio Expander has been tested and
found to comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labeling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Operations Guide – DOC. 6460A Audio Expander: Adagio AAE
• 5