Canon VB-C10R - Manual (Page 26)

2-2
Before Using the VB-C10/VB-C10R
Installing the VB-C10/VB-C10R
VB-C10 Installation
Install in a flat and stable location.
VB-C10R Installation
Firmly tighten the 2 screws (not supplied).
(Installation)
• Distance between tapped holes: 120 mm (4
18 /
25
in.)
• Tapped hole diameter: 6.0 mm ( 1 /
4
in.)
• Mounting plate thickness: 1.6 mm ( 1 /
16
in.)
Screw
VB-C10R
Mounting plate
Screw
a WARNING:
Install the camera securely.
● When installing the VB-C10R on the ceiling, contact your Canon dealer.
● When installing the VB-C10R on the ceiling, check that the ceiling is strong enough to
bear the weight of the VB-C10R including the mounting plate. Installation in a weak location
could result in the VB-C10R falling and causing serious injury.
● At least once a year, check for looseness in the camera installation mount. (If the optional
wide-angle converter is used, check the converter mount also.)
Note
● The permissible camera installation angles are ±20° from the horizontal. (±15°
when the optional wide-angle converter is used for the VB-C10.)
● The MAC address required when making network settings is shown on the bottom of
the VB-C10/VB-C10R (
→ P.1-11). Please make a note of it before installing this unit
(
→ P. 3-3).
Note
● Do not overtighten the mounting screw.
If excessive force is used to tighten the mounting
screw, camera head movement may be impeded,
or other malfunctions may result.
● Always use a tripod mounting screw that is less
than 6.0 mm ( 1 /
4
in.) in length. The use of screws
6.0 mm ( 1 /
4
in.) long or longer could damage the
camera. Also, the tripod seat used should be at
least 30 mm (1
3 /
16
in.) in diameter.
Using a Tripod (VB-C10)
The screw for mounting a tripod is on the bottom of the VB-C10 toward the front.
Mounting
screw
Less than
6.0 mm
(
1 /
4
in.)
30 mm
(1
3 /
16
in.)
or wider