Canon VB-C10R - Manual (Page 50)

3-20
Detail Settings
WebView Livescope Setting Settings Page
Make the various settings such as the number of simultaneous clients, frame rate, and maximum
camera control time.
“Restrict Service Time”
When you want to set a time for videos to be
distributed to the WebView Livescope Viewer, select
this option, and specify the Start and Stop times.
With Admin Viewer, connections can also be made
and videos viewed at times other than those set
(
→ P.4-24).
WebView Livescope
“Video Transmission Port”
Set a TCP port number to be used for transmitting videos
between the VB-C10/VB-C10R and the WebView
Livescope Viewer. Enter an integer between 1 and
65535. The default setting is 65310.
“Camera Control Port”
Set a TCP port number to be used for controlling the
camera between the VB-C10/VB-C10R and the WebView
Livescope Viewer. Enter an integer between 1 and
65535. The default setting is 65311.
“Maximum Number of Clients”
Sets the maximum number of clients that can
simultaneously be connected using the WebView
Livescope Viewer. Enter an integer between 1 and 20.
“Control Queue Length”
Sets the length of the queue when multiple clients are
waiting for control privilege under the WebView
Livescope Viewer. Enter an integer between 0 and 20.
The maximum number is 20. When set to “0”, only the
Admin Viewer is permitted to control the camera.
“Maximum Frame Rate (fps)”
Sets the maximum number of frames captured per
second. Enter a number between 0.1 and 30. The
maximum frame rate is 30 fps.
“Maximum View Time (sec)”
Sets the maximum time the clients can view videos using
the WebView Livescope Viewer. Enter an integer
between 0 and 65535. A setting of 0 disables the time
limitation (unlimited connection time).
“Maximum Camera Control Time (sec)”
Sets the maximum time one client can keep the camera
control privilege using the WebView Livescope Viewer.
Enter an integer between 1 and 3600. The maximum
control time is 3600 seconds.
“Camera Stabilization Time (msec.)”
When the GetStillImage command (
→ P.5-24) has been
requested, this setting specifies the delay to allow the
camera to stabilize before still picture is captured. Enter
an integer between 1 and 10000. The maximum delay is
10000 milliseconds.
Click the “OK” button to change the settings. To discard the changes, click the “Cancel”
button. This returns you to the settings title page.