Casio FX-9750GII - Manual (Page 109)

5-3
S To make V-Window settings
1. From the Main Menu, enter the GRAPH mode.
2. Press
Rectangular coordinate parameter
Xmin/Xmax … Minimum/maximum x -axis value
Xscale … Spacing of x -axis increments
Xdot … Value that corresponds to one x -axis dot
Ymin/Ymax … Minimum/maximum y -axis value
Yscale … Spacing of y -axis increments
Polar coordinate parameter
T Q min/TQ max ... Minimum/maximum T, Q
T Q ptch ... T, Q pitch
3. Press A to move the highlighting and input an appropriate value for each parameter,
pressing U after each.
• {INIT}/{TRIG}/{STD} … V-Window {initial settings}/{initial settings using specified angle
unit}/{standardized settings}
• {STO}/{RCL} … V-Window setting {store}/{recall}
After settings are the way you want them, press ) or
setting screen.
• Pressing U without inputting anything while I (busy indicator) is displayed exits the
V-Window setting screen.
S V-Window Setting Precautions
• Inputting zero for T Q ptch causes an error.
• Any illegal input (out of range value, negative sign without a value, etc.) causes an error.
• When T Q max is less than TQ min, TQ ptch becomes negative.
• You can input expressions (such as 2 P) as V-Window parameters.
• When the V-Window setting produces an axis that does not fit on the display, the scale of
the axis is indicated on the edge of the display closest to the origin.
• Changing the V-Window settings clears the graph currently on the display and replaces it
with the new axes only.
• Changing the Xmin or Xmax value causes the Xdot value to be adjusted automatically.
Changing the Xdot value causes the Xmax value to be adjusted automatically.
• A polar coordinate ( r =) or parametric graph will appear coarse if the settings you make in
the V-Window cause the T Q ptch value to be too large, relative to the differential between
the T Q min and TQ max settings. If the settings you make cause the TQ ptch value to be
too small relative to the differential between the T Q min and TQ max settings, on the other
hand, the graph will take a very long time to draw.
• The following is the input range for V-Window parameters.
–9.999999999
E
97 to 9.999999999
E
97