Pivotal Powersports Quick Connect Terminal - Manual

Quick Connector Installation Guide
To install our LED Light pods using our Quick
Connector terminals, please follow these
instructions.
After connecting the power wire to the battery, fuse
holder and switch and/ or optional remote, lift all
the orange securing levers on Quick Connect
terminals. When the securing lever is in the up
position, it allows you to insert the wire into the
terminal. When the securing lever is in the down
position, it locks the wiring into the terminal.
Strip each wire that will be connected to the
terminal back 10mm. Run the negative power wire
into one terminal, and run the positive wire into the
another terminal. Use two separate Quick Connect
terminals for installation, one for all the negative (-)
wires, and a separate one for all the positive (+)
wires (Never combine both negative and positive
wires in the same Quick Connect terminal, this will
result in damage to your LED Lighting Kit and/ or
vehicle).
Continue filling each terminal with the appropriate
wires until all lights are connected. Secure the Quick
Connect terminals to the vehicle using double sided
tape or zip ties, making sure to mount them away
from any high temperature objects like an exhaust.
Remember, it is ok to have multiple wires connected
and secured by one lever, but try to spread out the
wiring evenly through the securing levers of the
Quick Connect terminal.
Note: For those individuals that are not technically inclined, we would strongly
recommend that you bring your vehicle to your local mechanic or installer and
have them install the part or parts for you. Pivotal Powersports Corp. is not
responsible for the installation of any of our products.
If you have any additional questions, please contact
us at [email protected] Thanks!
Copyright © 2008 Pivotal Powersports Corp. / All Right Reserved