Pro Boat PRB2000 Addendum - Manual

The parts shown above are included in a separate bag within
your ShockWave
™ packaging. It may not be necessary for all
of these parts to be installed in every application.
Section 1: To prevent stripping of brass insert
for cable collet
Note: If your collets brass insert has already stripped and you are
experiencing drive system failure, proceed directly to Section 2.
1) Loosen the 3/32" set screw in the rudder control arm. Slide
the rudder down and remove from rudder mount. See Figure 1.
Note: Keep two white nylon bushings in a small
container to avoid misplacing them.
2) Loosen the two 5/64" set screws on the brass flex cable
collar. Pull the propeller shaft assembly out to the rear of
the boat. See Figure 2.
3) Push the flex cable through stuffing box and into the collet
as far as it will go without excessive binding.
4) Slide the propeller assembly back into the rear of the strut
as shown. Add the included spacers to the front of the strut
to take up the gap created between the strut and the brass
flex cable collar. See Figure 3.
5) Add screw-locking compound to the 5/64" brass flex cable
collar set screws and tighten. See Figure 4.
Note: If both setscrews do not come in contact
with the propeller shaft, you must use the new
shaft included with this addendum.
DRIVE SYSTEM ADDENDUM
TM
Figure 1
Figure 3
Figure 2
Figure 4
TM
PRB2008
PRB2031
PRB2032
Bushing
Flex Cable Coller
(Brass Ferrule)
Stuffing Box
Strut