Pro Boat PRB8100 - Manual

Marine Engine Starting
System
For use with Dynamite® .15 (PRB8100) and
.32 (PRB8105) marine engines
Introduction
Thank you for purchasing the Pro Boat™ Marine
Engine Starting System. This unit removes the
frustration of pull-starts by electrically starting nitro
engines. Once installed, the Marine starting system
allows you to start the engine by simply installing
the wand into the Tiger Drive and pressing the
starting button.
The provided shims and adapter plate allow quick
and straightforward installation and in most cases,
can be installed without removing the engine from
the boat.
Features
• High quality Tiger Drive creates a 90-degree
starting angle for easy access
• Adjustable drive unit for starting at an angle
• Uses existing Dynamite backplate and bearing
• High-torque portable rotary starter powers up
the engine with just the push of a button
• Powered by a standard 7.2V battery pack
(sold separately)
Installation
Step 1: Remove the 4 screws and pull-starter
including the one-way shaft.
Note: The pull-starter is
spring loaded. Use caution
during disassembly.
Step 2: Using the screws that previously mounted
the pull-starter, attach the adapter plate to the
engine. Use screw-locking compound on all screws.
Note: Adapter plate not required
for use with .15 marine engine.