Chamberlain WD962KLD - Manual (Page 33)

33
Using the Wall-Mounted Door Control
THE MOTION DETECTING DOOR CONTROL
Press the push bar to open or close the door. Press again
to reverse the door during
the closing cycle or to stop
the door while it’s opening.
This door control contains
a motion detector that
will automatically turn on
the light when it detects
a person entering the
garage. This feature can
be easily turned off for
extended work light use.
Light feature
Press the Light button
to turn the opener light on or off. It will not control the
opener lights when the door is in motion. If you turn it on
and then activate the opener, the light will remain on for
4-1/2 minutes. Press again to turn it off sooner. The 4-1/2
minute interval can be changed to 1-1/2, 2-1/2 or 3-1/2
minutes as follows: Press and hold the Lock button until
the light blinks (about 10 seconds). A single blink indicates
that the timer is reset to 1-1/2 minutes. Repeat the
procedure and the light will blink twice, resetting the timer
to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval,
etc., up to a maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you fi rst disable the motion sensor. See
Motion Detecting Light Feature, following.
Motion Detecting Light Feature: The opener light will turn
on automatically when a person walks in front of the wall-
mounted door control. This feature works by detecting
motion and body heat and may not work in temperatures
around 100˚ F, 37.7˚ C. The opener light will come on for
fi ve minutes, then shut off automatically if no additional
motion or heat differential is calculated.
To disable this feature, slide the detector switch on the
right side of the door control down (off).
We recommend that you disable the motion sensor when
using the opener lights as working lights. Otherwise, they
will turn off automatically if you are working beyond the
sensor’s range.
Additional feature when used with the
3-button hand-held remote
To control the opener lights:
1. With the door closed, press and
hold a small remote button that
you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights fl ash, release all buttons.
Lock feature
Designed to prevent operation of the door from hand-
held remote controls. However, the door will open and
close from the Door Control, the Outside Keylock and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The push bar light will fl ash as long as the Lock feature is
on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop fl ashing. The Lock
feature will also turn off whenever the “learn” button on
the motor unit panel is activated.
Push Button
Detector
Switch
Light
Button
Lock
Button