Ram Trucks 2011 3500 - User Guide - Manual (Page 46)

Changing The Volume
• Start a dialogue by pressing the Voice Command button , then say a
command (for example, “tutorial”).
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a
comfortable level while the Voice Command system is speaking. The volume
setting for Voice Command is different than the audio system.
• For vehicles equipped with Video Entertainment System (VES)™, refer to the
Uconnect™ Voice Command section of the Uconnect™ User's Manual on the
DVD for further details.
• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on
the DVD for Uconnect™ Voice Command information.
NOTE: To access the tutorial, press the Voice Command button . After the
BEEP, say “tutorial”. Press any hard-key/button or touch the display (Touch-Screen
radio) to cancel the tutorial.
WARNING!
Any voice commanded system should be used only in safe driving conditions
following local laws and phone use. All attention should be kept on the roadway
ahead. Failure to do so may result in a collision causing you and others to be
severely injured or killed.
iPod ® /USB/MP3 CONTROL
• There are many ways to play music from iPod ® players or other portable
devices through your vehicle's speakers. Your choices depend on what radio
your vehicle is equipped with.
• The radio sales code is located on the lower right side of the radio faceplate.
If Equipped with Media Center 730N (Sales Code RER)
• This feature allows you to plug an
iPod ® device into the vehicle’s
sound system through the iPod ®
Control port.
• The iPod ® Control port is located
inside the upper glove box. To get
into the iPod
® Control mode from a
touch-screen radio, press the MEDIA
hard-key, then touch the AUX or
iPod
® soft-key.
ELECTRONICS
44