ScanTool Ready-or-Not User Manual

Bc d, Launch obdwiz software, Technical support

Advertising
background image

1. Install OBDwiz software

2. Locate the diagnostic connector.

Insert the software CD in your CD-ROM drive.
The scan tool selection menu will automatically
appear. Click on the icon labeled Ready-or-Not:

5. Launch OBDwiz software

To launch the software, click on Start
Programs

. Click the Auto

Detect button, then click the Connect button.

6. Technical support

Should you run into problems, technical support
is just a click away:

3. Connect Ready-or-Not (RoN) to

the DLC

Follow connection diagram (directly below) to
connect RoN to the diagnostic connector using

The Ready-or-Not menu will appear. Click on

the black OBD-II cable (steps & ).

OBDwiz and follow the prompts to install the
software:

4. Connect scan tool to the PC

Connect RoN to your PC's serial port using the
gray serial cable (steps & ). Turn the vehicle’s
ignition to the Key On, Engine Off position.

Note that some laptops do not have a built-in
serial port. Inexpensive USB to Serial converters
are available from the ScanTool.net website, or
your local computer store.

º

If the menu does not appear, click Start

Run,

type D:\setup.exe (where ‘D’ is the drive letter of
your CD-ROM drive), and click OK.

Watch the LEDs as you are performing step .
The six monitor LED’s will momentary light up
green then red, followed by a “beep” sound.

The 16-pin D-shaped diagnostic link connector

g

(DLC) should be located in the passenger or

gOBDwizgOBDwiz

driver's compartment in the area bounded by the
driver's end of the instrument panel to 300 mm
(~1 ft) beyond the vehicle centerline, attached to
the instrument panel and easy to access from the
driver's seat. The preferred location is between
the steering column and the vehicle centerline.

Knowledgebase - contains answers to
the most commonly asked questions,
general information about OBD-II, and
troubleshooting information.

Forum - allows you to share information
and get support from other ElmScan 5
users.

All of the above resources can be accessed from
our website:

A

B

B

C

D

www.ScanTool.net

.

TM

A

vehicle

OBD-II cable

serial cable

B

C

D

Ready-or-Not

Ready-or-Not

Ready-or-Not

Ready-or-Not

Ready-or-Not

Ready

-or-

Not

TM

CA

T

EV

AP

SEC.

AIR

O

2

O

HTR

2

EGR

READY

NOT READY

RoN

computer

Advertising
Table of contents