Vacuflush, 4800 toilet series system wiring diagram, 4800 toilet series flush switch installation – SeaLand VacuFlush 4848 Toilet User Manual
Page 2
VacuFlush
®
4800 ToileT seRies sYsTeM wiRiNG DiaGRaM
VacuFlush 4800 series toilets feature a wall-mounted flush switch to control the “Flush” and “Add Water” functions. Follow the instructions below for standard Dometic flush switch installation.
STEP 1: Select a location for the flush switch. Eight feet of cable (2.4 m) is provided to reach the
toilet base. You may need to supply more wire, depending on how far you locate the flush switch
from the toilet.
STEP 2: Use the template to mark the center of the 1.75-inch (45 mm) hole.
STEP 3: Drill the 1.75-inch (45 mm) hole.
STEP 4: Insert switch assembly through the hole. Make sure the switch panel is level, then mark the
four mounting holes.
VacuFlush
®
4800 ToileT seRies Flush swiTch iNsTallaTioN
STEP 5: Remove the switch assembly from the large hole, then drill the four mounting holes with a
3/32-inch or 7/64-inch diameter drill bit.
STEP 6: Assemble the switch assembly to the wiring harness that connects to the toilet. Insert switch
assembly through hole and secure to wall using the four fasteners provided.
STEP 7: WITH THE ELECTRICAL POWER OFF, connect the wiring harness from the flush switch to
the five-conductor cable at the toilet.
DOMETIC FLUSH SWITCH DIAGRAM
To install other popular marine wall switches (Vimar, Gewiss), follow the instructions supplied by the switch manufacturer and the wiring diagram below.
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation
600345378 7/09
Dometic corporation, sanitation Division
13128 State Rt. 226
Big Prairie, OH 44611-0038 USA
1-800-321-9886