SIG SAUER 1911 Ultra Addendum - Manual

www.sigsauer.com
when it counts ™
5 .1 Field Stripping the Pistol
1. Always make sure the magazine is removed and the pistol is not loaded. Strip
and clean your pistol after every use and when exposed to dirt, sand, water, etc.
2. Retract the slide until the disassembly notch is aligned with the top of the slide
stop.
1911 ULTRa HandLinG & SaFeTY
inSTRUCTiOnS addendUM
3. Push the slide stop shaft from the right side of the pistol until you can grasp and
remove the slide stop from the left side of the pistol.
4. With the slide stop removed, gently ease the slide forward and off the frame.
The slide is under spring tension. Use caution.
5. Holding the slide assembly upside down, press the recoil guide forward to ease
the spring tension from the barrel lug. Once the tension is relieved, lift the recoil
guide up and out of the slide.
6. Remove the recoil spring plug.
7. Push the barrel forward through the front of the slide.
Step 2 Step 3
Step 5
11SIG481_1911_ManualAddendumInsert.indd 1 8/30/11 12:55 PM