Carrier Access Access Bank II SNMP User Manual
Access bank ii - snmp
Advertising
Table of contents
Document Outline
- Access Bank II Cover
- FCC Requirements
- Safety Requirements
- National Electrical Code Requirements
- Industry Canada Requirements
- Warranty
- Warranty Product Returns
- Advice to the Reader
- How To Use This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Product Description
- Chapter 3 Technical Specifications
- 3.1 About This Chapter
- 3.2 Dual T1 Network Line Interfaces
- 3.3 Line Codes
- 3.4 Framing
- 3.5 Clock Source
- 3.6 T1-to-T1 Delay
- 3.7 T1 Channel Service Units (CSUs)
- 3.8 Digital Data Ports
- 3.9 Analog Line Interfaces
- 3.10 FXS Voice Card
- 3.11 FXO/DPT Voice Card
- 3.12 4-Wire E&M/TO Voice Card
- 3.13 Network Management
- 3.14 Alarms
- 3.15 Control Panel I/O Connectors
- 3.16 Standards Compliance
- 3.17 Power
- 3.18 Environmental
- 3.19 Installation
- Chapter 4 Physical Installation
- Chapter 5 Electrical Installation
- Chapter 6 Basic Configuration
- Chapter 7 Remote Monitor
- Chapter 8 FXS-ID Configuration
- Chapter 9 BRFXS & DPO
- Chapter 10 12-Channel FXO & DPT
- Chapter 11 4-Wire E&M/TO
- 11.1 About This Chapter
- 11.2 4-Wire E&M/TO Voice Card
- 11.3 Typical Applications
- 11.4 E&M Signaling Conventions
- 11.5 Programming E&M Signaling Types
- 11.6 Detector Configuration
- 11.7 Normal and Tandem Cables
- 11.8 Configuring Signaling Types and Trunk Processing
- 11.9 TP Busy/Idle Switch
- 11.10 Setting Transmit and Receive Gain
- 11.11 Transmit (Analog-to-Digital) Gain
- 11.12 Receive (Digital-to-Analog) Gain
- 11.13 E&M Voice Channel Monitoring
- 11.14 E&M Normal mode cable
- 11.15 E&M Tandem Mode Cable
- Chapter 12 Diagnostics & Troubleshooting
- 12.1 About This Chapter
- 12.2 Diagnostic Switches
- 12.3 Self Test 1 and 2
- 12.4 Self Test Fault Indications
- 12.5 1 kHz Digital Milliwatt Test Signal
- 12.6 Network Loopback 1 and 2
- 12.7 Remote Mode: Remote T1 Line or Payload Loopbacks
- 12.8 ANSI T1.403 Remote T1 LLB
- 12.9 Illustrations of Loops and Self-Tests
- 12.10 Disabling an External Alarm
- 12.11 LED Test and Status Indicators
- 12.12 Fault Isolation Procedures
- 12.13 Back Plate Indications
- 12.14 Other Fault Indications
- 12.15 Access Bank II - SNMP Shuts Down for No Apparent Reason
- Chapter 13 Maintenance
- Chapter 14 SNMP Management & CLI
- Glossary