Solvline Eddy Serial Ver 2.1.0.3 - Manual (Page 60)

Chapter7. Appendix
60
Commands Default Descriptions
def port 1 flow
[none/xon/rts]
none Set the flow control scheme.
def port 1 signal
[data/modem]
data
Set the signal line checking method for the device to be
connected to the given serial port.
def port 1 remote
<IP address>
0.0.0.0
When the Operation Mode is set to TCP Client or UDP Client,
set the IP address to connect to.
def port 1 remoteport
<socket number>
4000
When the Operation Mode is set to TCP Client or UDP Client,
set the socket number to connect to.
def port 1 keepalive
<0 ~ 65535>
0
After a certain amount of time passes without any
communication after the socket connection between the given
serial port and the server is established, automatically
disconnect the socket connection.
def port 1 latency
<msec>
180
This needs to be set when consecutive data from the given
serial port needs to be transmitted to socket at once.
def port 1 login
[Enable / Disable]
Disable
When the Operation Mode is set to TCP Server, ask for the
username and password when the client tries to connect. Set
to 1 to enable.
def port 1 loginname
<username>
None
When the Operation Mode is set to TCP Server, set the
username to ask for(Max 8 bytes)
def port 1 loginpass
<password>
None
When the Operation Mode is set as TCP Server, set the
password to ask for( Max 8 bytes)
6.6 Username/Password Commands
Configure username and password for Web/Telnet/FTP.
Commands Default Descriptions
def username
<username>
eddy
Set username to use in Web, Telnet, or FTP.
16 Characters at maximum.
def password
<password>
99999999
Set password to use in Web, Telnet, or FTP.
16 Characters at maximum.
6.7 System Commands
Commands Descriptions
def default
Restore all settings to factory default. Requires reboot for changes to
take effect.
def save
Save current configuration settings. Requires reboot for changes to take
effect.
reboot Reboot Eddy.