Sonics FC User Manual
Page 2
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L F C P O W E R S U P P LY
1
W A R N I N G
SAFETY PRECAUTIONS
READ BEFORE INSTALLING OR USING THE EQUIPMENT
This system has been designed to assure maximum operator safety.
However, no design can completely protect against improper usage. For
maximum safety and equipment protection, observe the following warnings at
all times and read the instruction manual carefully before you attempt to
operate the equipment.
– High voltage is present in the equipment. Disconnect plug before removing
cover or servicing.
– Make sure equipment is properly grounded with a 3-prong plug. Before
plugging in equipment, test outlet for proper earth grounding.
– Ultrasonic welders operate above normal audibility for most people. Ear
protection is recommended. Consult the Appendix for a list of
manufacturers of ear protectors
Sonics & Materials, Inc.
Corporate Headquarters
European Office
53 Church Hill Road • Newtown, CT 06470 USA
22 ch du Vernay • CH - 1196 Gland, Switzerland
203.270.4600 • 800.745.1105 • 203.270.4610 fax
(41) (0) 22/364 1520 • (41) (0) 22/364 2161 fax
www.sonicsandmaterials.com • [email protected]
Information contained in this manual is subject to change without notice. Sonics & Materials, Inc. is not responsible for any typographic errors.
© Sonics & Materials, Inc. 2000
Printed in U.S.A.
Part No. 381-0031