Sonics GXE - Manual (Page 42)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X E P O W E R S U P P LY
40
PLC SAMPLE CODE
The following ladder file is a simple demonstration routine to roll the external
job selection from job 1 through 15 then restart at job 1 again. This routine
will switch jobs as fast as possible because the next job code is generated
and set during the previous weld cycle. The job is ready before the previous
cycle is completed.
Go To Top Of Document