Canon EOS 60D - Manual (Page 134)

134
D Using the Built-in Flash
FE (flash exposure) lock obtains and locks the standard flash exposure
reading for any part of a subject.
1
Press the <D> button to pop-up
the built-in flash.
Press the shutter button halfway and
look in the viewfinder to check that
the <D> icon is lit.
2
Focus the subject.
3
Press the <A> button. (8)
Aim the viewfinder center over the subject
where you want to lock the flash
exposure, then press the <A> button.
X The flash will fire a preflash and the
required flash output is calculated
and retained in memory.
X In the viewfinder, “FEL” is displayed
for a moment and <d> will light.
Each time you press the <A> button, a
preflash is fired and the required flash output
is calculated and retained in memory.
4
Take the picture.
Compose the shot and press the
shutter button completely.
X The flash is fired when the picture is
taken.
A FE LockN
If the subject is too far away and beyond the effective range of the flash, the
<D> icon will blink. Get closer to the subject and repeat steps 2 to 4.