Swimline 58001 Page 1 User Manual

Swimline Accessories for water

Advertising
background image

Commercial Reel System

For In Ground Solar Pool Covers

With Height Adjustable to 40”

Item #58001 Instructions

3 INCH RANGE POLE SET ASSEMBLY:

• Loosely assemble extruded tubes together. Slide excess width into adjoining tubes, dividing it up as equally as possible.

Note: You must have a minimum of 9” of overlap in each tube!

• Measure the width across the pool from plug surface to plug surface & adjust length of the tube assembly to fit the span.

• Lock the tubes together by rotating each adjoining tube in the opposite direction. (See Figure C)

• Secure each tube with just 1 self drilling screw in each adjoining tube.

• Attach the tube assembly into the Crank and Tubing Plugs and check for fit. Assemble Tube assembly together with

Crank Handles and Tube Plugs by lining up hole in the end of each tube fitted into Crank Handle and secure with metal

Axle Bolt and nut provided.

• When all is OK drill and screw the remaining screws at each end of the overlapped poles. You should have 6 screws on

each tube end where there is a connection.

9. Attach Straps to Tubes:

Come in 6 inches from each tube end and attach a strap plate to the aluminum tube assembly. Use the self drilling screws

on the drill line to attach the plate. Look at the holes that were pre-drilled at the factory and use the same drill line. There

are 6 lines on each tube. Take the remaining strap plates and connect them evenly along the length of the tube assembly.

Attach Straps to strap plate. (See Figure D)

10. Attach Solar Blanket to Straps:

If Wheel is to be placed at the end of the pool, attach cover to strap plate with plastic screw as shown in Figure

Below Left. If Wheel is to be placed in offset position, then attach cover to strap plate forming a fold to act like a hinge and

the plastic screw will go through two layers of the solar blanket as shown in Figure F Below Right.

Bubbles should face down.

Solar Blanket

Strap & Bracket

Plastic Screw

Solar Blanket Folded

Plastic Screw

Strap & Bracket

Twist

Tubing To

Remove

Excess

Play Prior

To Screwing

Together.

Thread

Strap

as Shown

Fig. C

Fig. D

Fig. E

Fig. F

3 INCH RANGE
POLE SET
ASSEMBLY:

Minimum

9"

Overlap

Measure Plug Surface To Plug Surface

Use Large Plug

For Pole Kit 5116

Only!

Fasten

With

Axle

Bolt

Fasten

With

Axle

Bolt

Fasten with

6 screws at each join

in pre-drilled holes

Fasten with

6 screws at each join

in pre-drilled holes

4&5 INCH RANGE POLE SET ASSEMBLY:

• Follow instructions as above except...

• When all is OK drill through holes in large outer tubes using pre-drilled holes as a template. Drill from each side with

Drill Bit supplied.

• Fasten with 2 Bolts & Nuts at each join. Bolts are at right angles to each other

Fasten

With

Axle

Bolt

4&5 INCH RANGE
POLE SET
ASSEMBLY:

Minimum

9"

Overlap

Fasten with

2 Bolts at each join

(pre-drilled in outer tube)

Fasten with

2 Bolts at each join

(pre-drilled in outer tube)

Fasten

With

Axle

Bolt

Measure Plug Surface To Plug Surface

Advertising