Tii 166 SERIES - Manual

TII P/N: _92218701
TII 166 SERIES
141 Rodeo Drive Wire Terminal Enclosures
Edgewood, NY 11717 Rev C 02/08
Customer Service/Sales 888-844-4720
INSTALLATION NOTE
1. GENERAL

The TII 166 Series Wire Terminal
Enclosures are used to connect drop
wire and bridal wire for aerial wire drops.
The enclosure is manufactured of
rugged heavy duty weather resistant
plastic.
2. INSTALLATION

Locate the elongated mounting holes at
the bottom of the enclosure and remove
the flashing across the mounting holes.

Use approved hardware to mount the
enclosure to the surface/pole.

Once the TII 166 has been mounted,
the Telco side cable(s) and customer
side cable(s) can be terminated to the
wire terminal studs.

Observe approved wiring practices at all
times.

Feed the telco side cable(s) and the
customer side cable(s) through the two
entry grommets located at the bottom of
the enclosure

To terminate, attach the telco cable wire
under the bottom washer and nut of the
terminal
stud (Tip/Ring), securely
tighten nut.

After tightening the bottom nut, place
customer cable wire under the top
washer and nut of the terminal stud
(Tip/Ring) and securely tighten nut
(Figure 1).

When more than one cable is placed
under a nut, use washers between the
wires (Figure 1).

Use caution when terminating small
gauge wire on the terminal studs, as the
wires may catch in the threads of the
terminal and be cut or broken when nuts
are tightened.

Check all nuts to make sure they are
tight.

Perform approved testing on completed
installation.
TII 166-12-2-2
Telco Side Cable
Terminate Between
Washers Customer Side Cable
Terminate Between
Washers
Figure 1