Tii 62 Series User Manual

Tii Equipment

Advertising
background image

TII P/N: _92216901________

141 Rodeo Drive

TII 61 / TII 62 Series

Edgewood, NY 11716

Sealed Wire Termination Block

Customer Service/Sales 888-844-4720

11/07 Rev B

INSTALLATION NOTE

1. GENERAL

The TII 61 / TII 62 Series Sealed Wire
Termination Blocks are used where multiple
customer telephone wire terminations are to be
provided. The TII 61 / TII 62 Series provide
connections in the following configurations:

Model

Description

TII 61-2-11

4 Rocker IDC Bridge with 2 RJ-11
Cables Out

TII 61-4-11

4 Rocker IDC Bridge with 4 RJ-11
Cables Out

TII 62-4-11

8 Rocker IDC Bridge with 4 RJ-11
Cables Out

TII 62-8-11

4 Rocker IDC Bridge with 8 RJ-11
Cables Out

Installation is accomplished using standard
technician tools. The Insulation Displacement
Contacts (IDC) are achieved using gel sealed
rockers.

IDC Terminations accept 26-22 AWG solid
wire.

2. INSTALLATION

Remove the TII 61 / TII 62 Sealed Wiring
Termination Block and inspect it for damage.
If damaged, obtain another unit.

Align the wire termination block with the
mounting holes on the designated PC board.
Use suitable hardware to attach the block to
the PC board.

Plug in RJ-11 plugs into the corresponding
RJ-11 jacks.

Lift the rocker of the input terminal to the full
up position. DO NOT strip wires. Hold the
customer telephone wire pair to be terminated
between thumb and index finger. Insert wires
into wire guides simultaneously until they
bottom-out. While holding wires in position,
terminate rocker by lowering to the full DOWN
position.

Terminate any additional input or out pairs as
required following the above steps.

To keep wire pairs organized, route them
through the molded wire looms as shown in
Figure 1.

Figure 1

TII 61

TII 62

IDC ROCKER IN

UP POSITION

WIRE GUIDES

IDC ROCKER IN
DOWN/TERMINATED
POSITION

Advertising
This manual is related to the following products: