Connecting to an sfp module, To comp, Step 2 – Cisco 3750 User Manual
Page 36
2-18
Catalyst 3750 Metro Switch Hardware Installation Guide
OL-9160-02
Chapter 2 Switch Installation
Connecting to an SFP Module
Note
When you connect to 1000BASE-T-compatible devices, be sure to use a twisted four-pair,
Category 5 or higher cable. See the
“Four Twisted-Pair Cable Pinouts for 10/100 Ports” section
for more information.
Figure 2-15
Connecting to an Ethernet Port
Note
You can use the mdix auto interface configuration command in the CLI to enable the automatic
crossover feature. When the automatic crossover feature is enabled, the switch detects the
required cable type and configures the interfaces accordingly. Therefore, you can use either a
crossover or a straight-through cable for all connections to an Ethernet port on the switch.
The automatic crossover feature is disabled by default. For configuration information for this
feature, refer to the switch software configuration guide or the switch command reference.
Step 2
Connect the other end of the cable to an RJ-45 connector on the other device. Repeat Steps 1 through 3
to connect each device.
Connecting to an SFP Module
This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic
SFP modules, see the
“Connecting to a Fiber-Optic SFP Module” section on page 2-19
section. For
instructions on how to connect to 1000BASE-T SFP modules, see the
section.
For instructions about how to install or remove an SFP module, see the
1
Connector cable
1
2
3
4
5
6
7
8
9
10
11
12
1X
2X
11X
12X
CONSOLE
PWR A
SYST
PWR B
MASTR
STAT
DUPLX
SPEED
STACK
MODE
97441
1